Categories

Contact Us

CANGAS Systems Company Limited

B516, GID International Center, 27 Nanbinhe Road, Xicheng District, Beijing, China 100055.

Factory: Shidai Road East, Gu'an Industrial Zone, Langfang City, Hebei Provice.

Phone: +86-10-63338130

Fax: +86-1063338230

E-mail: sales@can-gas.com

Website: www.can-gas.net

www.can-gas.com

Knowledge

Home > Knowledge > Content

Liquid nitrogen generator for sale

CANGAS Systems Company Limited | Updated: Jun 24, 2016

General Introduction to Cryogenic nitrogen plant

  The main purpose of a cryogenic nitrogen plant is to provide a customer with high purity gaseous nitrogen. In addition liquid nitrogen (LIN) is produced simultaneously and is typically 10% of the gas production. High purity liquid nitrogen produced by cryogenic plants is stored in a local tank and used as a strategic reserve. This liquid can be vaporised to cover peaks in demand or for use when the nitrogen plant is offline. Typical cryogenic nitrogen plants range from 250 Nm3/hour to very large range plants such as the a daily capacity of 90.000 tonnes of nitrogen a day.

How the plant works

Warm end process

    Atmospheric air is roughly filtered and pressurised by a compressor, which provides the product pressure to deliver to the customer. The amount of air sucked in depends on the customer’s nitrogen demand.

    The Air Receiver collects condensate and minimises pressure drop. The dry and compressed air leaves the air to refrigerant heat exchanger at about 10°C.

    To clean the process air further, there are different stages of filtration. First of all, more condensate is removed, this removes some hydrocarbons.

    The last unit process in the warm end container is the thermal swing adsorber (TSA). The Air purification unit cleans the compressed process air by removing any residual water vapour, carbon dioxide and hydrocarbons. It comprises two vessels, valves and exhaust to allow the changeover of vessels. While one of the TSA beds is on stream the second one is regenerated by the oxygen rich waste flow, which is vented through a silencer into the ambient environment.

Coldbox process

    After leaving the air purification unit, the process air enters the main heat exchanger, where it is rapidly cooled down to -165°C. All residual impurities (e.g. CO2) freeze out, and the process air enters at the bottom of the distillation column partially liquefied.

Back up process

    Liquid Nitrogen produced from the cold box transfers into the liquid storage tank. An ambient air vaporiser is used to vaporise stored liquid during peak demand. A pressure control panel senses the demand for gaseous nitrogen and regulates the gas flow into the end-users pipeline to maintain line pressure.

Applications for high purity nitrogen production

Ammonia production for the fertilizer industry

Float glass manufacture

Petrochemical

Purge gas

Blanketing/Inerting gas for tanks and reactor vessels

Amine gas treatment

Bearing seal gas

Polyester manufacture

Semiconductor manufacture

Photovoltaic manufacture



Our Service

Established in 1998, CAN GAS SYSTMES COMPANY LIMITED, a reputable manufacturer of on-site nitrogen and oxygen plants and kinds of gases systems, has a production and R&D center with an area of 28,000 square meters, and passed ISO9001 quality management certification, BV certification and CE certification.

Feedback

Tel: +86-10-63338130

Contact Us

Address: B516, GID International Center, 27 Nanbinhe Road, Xicheng District,Beijing, China 100055.

Home | About Us | Products | News | Knowledge | Contact Us | Feedback | Mobile | XML

Copyright © CANGAS Systems Company Limited

share: